Wall-Mounted 5T Rail, 200 kg Lifting

A production line laid out along a wall leaves only about an aisle's width to work in. Erecting gantry crane posts on the floor eats up that space, while carrying loads by hand means repeating the same motion all shift. The roof structure in this area often isn't convenient for hanging a rail either.

FullSharp builds a 5T rail (200 kg rated load) mounted on the wall through a bracket system and high-strength anchor bolts. A trolley carries the hoist the full length of the rail, serving every position along the route. With everything mounted against the wall, the aisle and floor space stay untouched.

Wall-Mounted 5T Rail for Wall-Adjacent Work Routes

A 5T rail mounted on the wall with a bracket system, trolley and hoist traveling the work route.

Equipment Installed

5T steel rail: runs along the wall, 200 kg rated load, cut to the length of the work route.
Wall bracket system: consoles fixed with high-strength anchor bolts, with support spacing engineered to the load and span.
Rail trolley: rolls smoothly, needs only a light push, and stops exactly where lifting is needed.
Hoist on the trolley: electric or manual hoist, chosen to match the work pace.
End stops on both ends of the rail: limit travel and keep the trolley from running off the rail.

Key Specifications

Rail type5T steel rail
Rated load200 kg
MountingWall-mounted with bracket system
Installation photos3 photos

Benefits for Your Workshop

Keeps the aisle clear

The rail and brackets sit against the wall, so the floor stays free.

Works with a weak roof

Loads transfer into the wall or columns, independent of the roof structure.

Covers the whole route

The trolley travels the full length of the rail, reaching every position along the route.

Real Installation Photos

Wall-Mounted 5T Rail for Wall-Adjacent Work Routes - photo 1

Wall-Mounted 5T Rail for Wall-Adjacent Work Routes - photo 2

Click a photo to enlarge. A 2-photo album taken on site.

Suitable Applications

Production lines laid out along a wall
Equipment maintenance and repair areas
Machining stations tight against a workshop wall
Material warehouses with narrow aisles

Get Advice for Your Workshop

FullSharp inspects your wall or column structure to determine anchor points and bracket spacing. Our technicians calculate rail length to match your actual route, then install, load-test, and hand over with guidance on periodic bolt checks.