FullSharp built an 80 kg pneumatic jib crane with a height-adjustable column on a counterweighted mobile base for a factory with several stations that each lift only a few dozen times a day. The unit is pushed to whichever station needs it, the stabilizers are lowered, and it works at once with no floor drilling or fixed wiring.
A factory may have several stations that each need to lift loads under 100 kg, but each station only handles a few dozen lifts a day. Installing a fixed column at every station is costly and takes up floor space, while consolidating them into one spot means workers have to carry goods a long way.
FullSharp builds an 80 kg pneumatic jib crane with a height-adjustable column on a mobile base. The whole unit is pushed between stations; once in place, lower the stabilizers and get to work immediately, with no floor drilling or fixed wiring needed.
80 kg pneumatic jib crane with a height-adjustable column on a mobile base, installed in a factory.
Push it to whichever station needs it, avoiding the cost of a fixed column at every position.
The column raises and lowers, so it fits low-ceiling zones while keeping enough lifting stroke.
No floor drilling, no fixed wiring — bring it into the factory and it's ready to run.
Yes. This mobile unit is pushed to whichever station needs it, avoiding a fixed column at every position. A counterweighted base keeps it steady at full reach.
The column is raised or lowered per station and locked, so it fits low-ceiling zones while keeping enough lifting stroke. FullSharp sets the height range from the customer's site.
A valve and air filter assembly removes moisture and dust before the cylinder. The 80 kg lifting unit then lifts smoothly by trigger and holds at any point in the stroke.
FullSharp measures the actual load at each station, the lowest ceiling height along the travel path, and the floor's flatness. From there we calculate the base counterweight, column travel, and swing arm reach. Contact FullSharp to schedule a site survey at your factory.