200 kg Pneumatic Jib Crane Installed in Hai Phong

FullSharp installed a 200 kg pneumatic jib crane at a factory workstation in Hai Phong where running a new power line was costly and two workers had been lifting each load by hand. The crane runs on the compressed air already in the plant, and the arm follows the operator's hand and holds position the moment it is released.

The factory needed a fixed lifting point for loads around 200 kg, but running a new power line to that spot was both inconvenient and costly. Workers were lifting each load by hand in pairs, wearing them out over a full shift. The location was also close to a walkway, so the equipment couldn't take up much space.

FullSharp installed a 200 kg pneumatic jib crane right at the workstation. The equipment runs on the compressed air already available in the factory, with the arm following the operator's hand and holding position the instant it's released, so a single person can operate it.

200 kg Pneumatic Jib Crane Installed in Hai Phong

The 200 kg pneumatic jib crane after installation at a factory in Hai Phong.

Equipment Installed

Column and rotating arm: the column is fixed to the floor, and the arm swings around it, covering a circular work area around the standing position.
200 kg pneumatic assembly: balances the load with compressed air, so the load holds its height the moment it's released.
Control handle: raise and lower buttons are on the handle, letting the operator work one-handed while steadying the load.
Air filter and regulator: separates moisture from the compressed air and keeps pressure stable for even lifting force.

Key Specifications

Load capacity200 kg

Benefits for the Factory

No new wiring needed

Runs on the factory's existing compressed air, so installation is quick and simple.

Operated by one person

A job that used to need two people lifting now takes just one operator.

Small footprint

Only a single column stands at the work point, keeping the walkway beside it clear.

Installation Photos

200 kg Pneumatic Jib Crane Installed in Hai Phong - photo 1

200 kg Pneumatic Jib Crane Installed in Hai Phong - photo 2

200 kg Pneumatic Jib Crane Installed in Hai Phong - photo 3

200 kg Pneumatic Jib Crane Installed in Hai Phong - photo 4

200 kg Pneumatic Jib Crane Installed in Hai Phong - photo 5

200 kg Pneumatic Jib Crane Installed in Hai Phong - photo 6

200 kg Pneumatic Jib Crane Installed in Hai Phong - photo 7

200 kg Pneumatic Jib Crane Installed in Hai Phong - photo 8

Click a photo to enlarge. Album of 8 photos taken on site.

Suitable Applications

Mechanical and metalworking shops handling medium loads
Feed and finished-part collection stations at machines
Assembly areas for heavy component clusters
Loading and unloading points inside the factory

Frequently asked questions

Can a jib crane run without electricity?

Yes. A pneumatic jib crane runs on compressed air. In this project it uses the plant's existing air supply, so no new power line was needed at the workstation.

How many people does a 200 kg pneumatic jib crane need?

One. The air unit balances the load, so the operator only guides it, and the arm stays where it is released. Before installation, two workers lifted each load together.

How much space does a column jib crane take?

Only the column footprint on the floor. The arm swings around it and covers a circular area around the operator, which suits spots close to a walkway. FullSharp checks reach and position on site.

Similar projects

Consultation for Your Factory

FullSharp surveys the foundation at the column location, measures the load weight and required reach, and also checks your factory's existing air pressure and flow before finalizing the configuration. Contact FullSharp to schedule a survey date.

200 kg pneumatic jib crane installed in Hai Phong, one column and run on existing air